| Subject | Text |
| sony trinitron KV-21STR2 blown q604 and q603 | hi there, im new on this forum, can anyone tell me and help me work for the power supply of sony tri |
| Re: sony tv kv29st70..picture does'nt show up.. | Trace back the flyback secondary supply voltage. also check the your heater. |
|
|
| Denon UDM3 No sound output | Hi guys, originally the cd tray wouldn't eject, found the fix for that on here thanks very much work |
| the only other way i use to enter the service mode is via the sony trace interface, replacing the ee |
| Anritsu S331D PLL fail | Hi, I have an Anritsu sitemaster S331D which fails self test with the error
PLL FAILED (2000,10) |
| Bob,
Before condeming any device, best to attempt to narrow it further.
Based on the age & |
| When you say. "digital setup", remember that music that you listen to, is and always will |
| Cut into CD input for MP3 | Hello, I would like to connect my mp3 player to the ribbon wire connecter from my built in CD player |
| [quote:5a5876d182="Anonymous"]I traced back to the input of the motor control IC (SIP #BA6209N) pins |
| Re: Ilo 32 quick inverter question... | [quote:2227ac3c45="teamitr"]Not familiar with the specifics of the set but, for the balast-on line, |
| Regulators in parallel? | I well belive you are being driven MAD!
Simply put, it's WRONG, there is no way that two 7805 type |
| Re: Service Manuals | [color=red:756723afa0]Schematics[/color:756723afa0] for these are as follows:
- NAKAMICHIA PA-7 A |
| Klipsch Promedia 2.1 Amplifier Schematic Requested | I purchased a Klipsch Promedia 2.1 off ebay without reading the fine print, and one channel of the A |
| hardon karmon 7 channel amplifier, 1 channel very low ?? | Difficult problem to solve maybe faulty transistor or lack of bias (supply rail?) resulting in clipp |
| While there is data for life expectancy of any device, there is no specific time line for capacitor |
| Onida candy tv | Dear members,
I have Onida TV candy model 20 inches. It was working well. suddenly no power. I ch |
| Adcom Motorized Pot. - Help | I have an old Adcom GTP-500 Tuner/Preamp that I dealry love. It still works great. My remote control |
|
|
| Check if there is any tape transport problem that causes wrinkling of the lower edge of the tape at |
| Pc Monitor truble AOC and Giant Optics | Hi, is there anybody who can help me about AOC Computer monitor model number:5EN. The Problem is on |
| Re: DX-LCD32-09 | [quote:96213f7367="gluna"]Hello all, so the this tv is great only 1 big problem. It turns on and sta |
| Sound Card Oscilloscope, Spectrum Analyzer, Signal Generator | PC version: http://www.virtins.com/SCMISetup.exe
Pocket PC version: http://www.virtins.com/PocketI |
| service manual marantz pm710dc | anyone a service manual fot marantz amplifier pm710dc
or sugestion to solve random rateling noise e |
| If the hum disappears completely when turning down the volume control, then the hum source must be b |
| Owner of three blown post diagnostic cards requires help... | Owner of three blown post diagnostic cards requires your help...
Problem is that China Inc. actuall |
| [quote:e59dd6ff66="javelinpr"]i have the full schematics with the whole block diagrams, printed circ |
| surface mount soldering techniques | Has anybody got some surface mount soldering techniques
The first way I was taught to replace sur |
| Re: can anyone help out with code for Grundig Sound 4000a | [quote:68d8dca32a="spike"]Hi
Can anyone help with a code for a Grundig Sound 4000a? the serial |
| Re: HELP stero repair | [quote:2890bb5678="tim in pa"]my first post, thanks for reading. i am repairing my bosses (i know!) |
| teac receiver- protect mode, all output transistors are ok. | like the title says, TEAC AG-V8500, I cant seem to figure out why this receiver is going into protec |
| LG RZ-20LA70 LCD TV | A 20" LCD TV recently came into my hands that unfortunatley is just out of warranty. The unit stays |